15 Matching results
RYOBI Petrol Easy Start Cultivator difficult to start
If you’re having difficulties starting your RYOBI Petrol Easy Start Cultivator, make sure you follow the correct starting procedure. You should also check for a flooded engine, stale fuel, if the air filter needs cleaning, the choke has been left…
Last update: 29/08/2022, 11:25
Why does my RYOBI Petrol/Battery Cultivator vibrate excessively when in use?
If your cultivator vibrates excessively when in use, apply a small amount of general-purpose grease to the non-powered drive shaft to ensure a smooth operation.
Last update: 20/09/2022, 14:59
How to stop RYOBI Petrol/Battery Cultivator cutting out
If your RYOBI Cultivator keeps cutting out while in use, ensure the soil conditions are suited to your cultivator. If your model is 18V & 36V Battery, ensure that your battery is sufficiently charged before use. If your model is petrol, make sure…
Last update: 20/09/2022, 15:00
How to operate a RYOBI 36V Lawn Mower's self-propelled mode
The motor is controlled by the thumb paddle, which when pushed drives the mower forward. Speed is then controlled by the slider switch, which allows you to set your desired pace. We recommend starting off slow until you get used to it.
Last update: 11/07/2023, 10:00
How to reset a 36V RYOBI Lawn Mower's Blade Check warning light
To reset a 36V RYOBI Lawn Mower's blade check warning light, hold down the battery icon on the dashboard for 3 seconds.
Last update: 17/11/2022, 15:09
Understanding the RYOBI 36V Lawn Mower modes
A dashboard is located at the top of the Mower's handle. It provides a single point to set the three moving modes, and pressing the mode button cycles through each of the modes. ECO mode locks the blade in low speed to provide the best runtime, but…
Last update: 29/08/2023, 14:21
Understanding the RYOBI 36V Lawn Mower LED lights
The Blade Check warning LED is a handy reminder to check the condition of the blade. This reminder will pop up every 10 hours of use. Holding down the battery icon on the dashboard for 3 seconds will reset it and the 10 hour timer will begin again…
Last update: 29/08/2023, 14:08