How can we help?

• Chainsaws & Pruning Saws
• Pruning Saws
• Troubleshooting

Why doesn't my RYOBI Pole Pruner battery last?

Check your battery’s charge level indicator. Batteries will lose power as the charge reduces. If your battery is nearly depleted you will experience lower power than a fully charged battery. The larger the battery, the longer the chainsaw will run…

Last update: 20/09/2022, 14:49

• Chainsaws & Pruning Saws
• Pruning Saws
• Troubleshooting

Why is my 18V/36V RYOBI Pole Pruner not starting?

If your 18V or 36V RYOBI Pole Pruner isn't starting, it may be your battery - check your battery’s charge level indicator to ensure it's fully charged, check the battery is seated correctly and make sure the battery isn't too hot. Also, make sure…

Last update: 20/09/2022, 14:50

• Chainsaws & Pruning Saws
• Pruning Saws
• Troubleshooting

Why is my 18V/36V RYOBI Pole Pruner charger is not working?

If your 18V or 36V RYOBI Pole Pruner charger isn't working, make sure your battery is correctly inserted in charger, and that the battery isn’t hot. RYOBI batteries have overheat protection built into them. If the battery is too hot the charger will…

Last update: 20/09/2022, 14:52

• Chainsaws & Pruning Saws
• Pruning Saws
• Troubleshooting

Why does my 18V/36V RYOBI Pole Pruner leak oil when not in use?

Oil leaking is a common occurrence and does not signify an issue with your Pruner. Oil is pumped through grooves around the chain bar to ensure the chain and bar are lubricated correctly. Therefore it’s common and expected to have oil left in these…

Last update: 20/09/2022, 14:53

• Drills & Drivers
• Drill Drivers
• Troubleshooting

Cannot tighten Drill Driver Bit in RYOBI Drill Driver chuck

Check that the chuck securing screw has potentially loosened – tighten clockwise with a matching bit (PH3 or Torx T30 usually) This occurs when Bits are dropped all the way into the bottom of the chuck.

Last update: 11/09/2024, 16:11

• Drills & Drivers
• Drill Drivers
• Getting Started

What are the settings for on my Ryobi Drill Driver?

The settings are to help with drilling holes & driving screws properly into the desired material.

Last update: 11/09/2024, 17:42

• Drills & Drivers
• Drill Drivers
• Maintenance

How to replace the Drill Chuck

ALWAYS disconnect the tool from power before starting. You will need a PH3 Screwdriver, a 10-13mm Allen key & a Rubber Mallet. To start, locate the internal screw within the centre of the Drill chuck.

Last update: 11/09/2024, 17:52