7 Matching results
How to install or change RYOBI Multi Tool blade
To change blades, release the latch by pulling it upwards until the blade holder opens. Ensure the lever is fully released before removing or inserting a new blade. Once the new blade is inserted, pull down the lever until the blade holder snaps…
Last update: 18/09/2023, 09:59
How to operate a RYOBI 36V Lawn Mower's self-propelled mode
The motor is controlled by the thumb paddle, which when pushed drives the mower forward. Speed is then controlled by the slider switch, which allows you to set your desired pace. We recommend starting off slow until you get used to it.
Last update: 11/07/2023, 10:00
How to reset a 36V RYOBI Lawn Mower's Blade Check warning light
To reset a 36V RYOBI Lawn Mower's blade check warning light, hold down the battery icon on the dashboard for 3 seconds.
Last update: 17/11/2022, 15:09
Understanding the RYOBI 36V Lawn Mower modes
A dashboard is located at the top of the Mower's handle. It provides a single point to set the three moving modes, and pressing the mode button cycles through each of the modes. ECO mode locks the blade in low speed to provide the best runtime, but…
Last update: 29/08/2023, 14:21
Understanding the RYOBI 36V Lawn Mower LED lights
The Blade Check warning LED is a handy reminder to check the condition of the blade. This reminder will pop up every 10 hours of use. Holding down the battery icon on the dashboard for 3 seconds will reset it and the 10 hour timer will begin again…
Last update: 29/08/2023, 14:08
How to adjust a 36V RYOBI Lawn Mower's cutting height
To adjust the cutting height, slide the adjusting lever forward to unlock. Then raise the cutting height or push the mower down to lower the cutting height. Release the lever to lock it in place.
Last update: 25/11/2022, 15:07
How to adjust a 36V RYOBI Lawn Mower's handle height
To adjust a 36V RYOBI Lawn Mower's handle height, unclip the two height adjustment clamps and pull the handle out to the desired position and lock it off. You can also adjust the angle of the handle by pulling the quick release fastener out and…
Last update: 21/04/2023, 12:28