How can we help?

• Drills & Drivers
• Drill Drivers
• Troubleshooting

Bit slips out of RYOBI Drill Driver when driving screws

Bits can slip if the tips are very worn or are poor quality. Try inspecting the tip of the Bit to ensure it is not excessively worn. You should also make sure you're using the correct Bit for the fastener. Refer to the fastener packaging for correct…

Last update: 22/08/2022, 17:09

• Drills & Drivers
• Drill Drivers
• Troubleshooting

Can't tighten Drill Driver Bit in RYOBI Drill Driver chuck

The chuck securing screw has potentially loosened - tighten to avoid dropping Bits all the way into the bottom of the chuck. Depending on the type of chuck, make sure when tightening that the Bit is seated on the chuck jaws with equal seating /…

Last update: 03/02/2023, 16:01

• Blowers & Garden Vacuums
• Blower Vacs
• Troubleshooting

RYOBI Blower Vacuum won’t start

If your RYOBI battery powered Blower Vacuum won’t start, first check if the battery is low. Check the battery has at least 1 solid bar on it’s fuel gauge. If there is a flashing single bar, it's indicating the battery is fully discharged. Recharge…

Last update: 16/08/2023, 11:52

• Blowers & Garden Vacuums
• Blower Vacs
• Troubleshooting

Why has my RYOBI battery-powered Blower Vacuum lost suction?

If your RYOBI Battery powered Blower Vacuum has lost suction and isn’t vacuuming well, make sure the bag is empty and clean, as this can impact the performance of the unit. Also check for debris in the tubes, around the propeller or in the elbow as…

Last update: 01/02/2023, 15:59

• Blowers & Garden Vacuums
• Blower Vacs
• Application

What is the metal wire inside my RYOBI battery powered Blower Vacuum?

This is an anti-static grounding device inside the unit and is meant to be there. Don’t attempt to remove or alter it.

Last update: 26/08/2022, 14:16

• Blowers & Garden Vacuums
• Blower Vacs
• Troubleshooting

RYOBI Blower Vacuum can’t switch between modes

If your RYOBI Blower Vacuum can’t switch between modes, it may be because of a build-up of debris in the lever or deep inside the elbow.

Last update: 26/08/2022, 14:33

• Blowers & Garden Vacuums
• Blower Vacs
• Application

How to adjust the support wheels position for a RYOBI 18V HP Garden Vacuum & Sweeper

To adjust the position of the support wheels on your RYOBI 18V HP™ Garden Vacuum & Sweeper, pull up the tab at the other end to the wheels will allow you to adjust the position of the wheels to best support the bottom of the tool.

Last update: 13/10/2022, 09:53