21 Matching results
Bit slips out of RYOBI Drill Driver when driving screws
Bits can slip if the tips are very worn or are poor quality. Try inspecting the tip of the Bit to ensure it is not excessively worn. You should also make sure you're using the correct Bit for the fastener. Refer to the fastener packaging for correct…
Last update: 22/08/2022, 17:09
Can't tighten Drill Driver Bit in RYOBI Drill Driver chuck
The chuck securing screw has potentially loosened - tighten to avoid dropping Bits all the way into the bottom of the chuck. Depending on the type of chuck, make sure when tightening that the Bit is seated on the chuck jaws with equal seating /…
Last update: 03/02/2023, 16:01
RYOBI Blower Vacuum won’t start
If your RYOBI battery powered Blower Vacuum won’t start, first check if the battery is low. Check the battery has at least 1 solid bar on it’s fuel gauge. If there is a flashing single bar, it's indicating the battery is fully discharged. Recharge…
Last update: 16/08/2023, 11:52
Why has my RYOBI battery-powered Blower Vacuum lost suction?
If your RYOBI Battery powered Blower Vacuum has lost suction and isn’t vacuuming well, make sure the bag is empty and clean, as this can impact the performance of the unit. Also check for debris in the tubes, around the propeller or in the elbow as…
Last update: 01/02/2023, 15:59
What is the metal wire inside my RYOBI battery powered Blower Vacuum?
This is an anti-static grounding device inside the unit and is meant to be there. Don’t attempt to remove or alter it.
Last update: 26/08/2022, 14:16
RYOBI Blower Vacuum can’t switch between modes
If your RYOBI Blower Vacuum can’t switch between modes, it may be because of a build-up of debris in the lever or deep inside the elbow.
Last update: 26/08/2022, 14:33
How to assemble a RYOBI 18V HP Garden Vacuum & Sweeper
First slide the guide wheels on to the lower blower tube. Once on, pulling up this tab allows you to adjust the position of the wheels to best support the bottom of the tool. Then attach this section to the lower vacuum tube by sliding it into…
Last update: 29/08/2023, 09:36