Search - RYOBI Support Australia

Drills & Drivers
Drill Drivers
Troubleshooting

Bit slips out of RYOBI Drill Driver when driving screws

Bits can slip if the tips are very worn or are poor quality. Try inspecting the tip of the Bit to ensure it is not excessively worn. You should also make sure you're using the correct Bit for the fastener. Refer to the fastener packaging for correct…

Last update: 22/08/2022, 17:09

Drills & Drivers
Drill Drivers
Troubleshooting

Can't tighten Drill Driver Bit in RYOBI Drill Driver chuck

The chuck securing screw has potentially loosened - tighten to avoid dropping Bits all the way into the bottom of the chuck. Depending on the type of chuck, make sure when tightening that the Bit is seated on the chuck jaws with equal seating /…

Last update: 03/02/2023, 16:01

Drills & Drivers
Impact Drivers
Troubleshooting

Bit slips out of RYOBI Impact Driver when driving screws

The chuck will accept the bit by clicking it into the chuck. The bit should not be able to be removed by just pulling on the end of it, you will need to lift the sleeve around the chuck to release the bit.

Last update: 11/09/2024, 16:04

Drills & Drivers
Impact Drivers
Troubleshooting

Can’t secure screwdriver bit in RYOBI Impact Driver

If you can't secure the screwdriver bit into your Impact Driver, check inside the spindle where the Bit is inserted to ensure there are no dirt or obstructions embedded inside that prevent the Bit from sitting correctly. Depending on the Impact…

Last update: 13/04/2023, 17:03