11 Matching results
Can you put a steel/wire brush on a RYOBI Bench Grinder?
Yes, you can put a steel/wire brush on your Bench Grinder. Make sure its diameter matches that of our recommended and existing Disc & Bore size, and that the RPM capability of the new Steel/Wire Brush is also rated to handle the RPM of the Ryobi…
Last update: 13/04/2023, 14:35
Is the RYOBI Bench Grinder compatible with sanding accessories?
The Bench Grinder is compatible with sanding accessories. However, ensure the chosen accessory is compatible with bench grinder use, and can achieve and/or deliver the intended result. Consider factors such as RPM compatibility and the different…
Last update: 13/04/2023, 14:37
How to fit & remove Angle Grinder disc using a pin spanner
If your RYOBI Angle Grinder has a pin spanner locking nut, you'll need a pin spanner to fit and remove the disc. Don’t attempt to remove the disc without one, as it may damage the spindle.
Last update: 29/08/2023, 13:19
RYOBI Angle Grinder disc has overtightened and jammed
An overtightened or jammed disc is usually caused by the disc not being installed correctly, causing it to overtighten. To fix this issue and prevent this from happening again, you’ll need to remove and refit the disc.
Last update: 29/08/2023, 13:25
Can’t remove cutting disc from Angle Grinder
Typically, a cutting disc can be hard to remove because the locking nut was overtightened when fitted to the grinder. A disc will tighten under loading, so excessive tightening will cause issues with removal, that may require a pin spanner or wrench…
Last update: 01/08/2023, 11:27
What size disc is suitable for a RYOBI Angle Grinder?
For a RYOBI 125mm Angle Grinder, the maximum disc capacity is 125mm/5 inches, so you need a 125mm disc. For a RYOBI 115mm Angle Grinder, the maximum disc capacity is 115m, so you need a 115mm disc. Don’t use a disc larger than the maximum cutting…
Last update: 02/08/2023, 10:07
RYOBI Edger not making clean defined edge
If your RYOBI Edger isn’t making a clean defined edge, check the condition of your blade and the depth you have set the blade set to. You should also check the locking nut is secured.
Last update: 25/08/2022, 13:55