8 Matching results
Why does my RYOBI Angle Grinder keep cutting out?
Angle Grinders are commonly equipped with several user safety and tool protection systems, such as overload, over-temperature, and anti- kickback. Consider the following that could be causing the issue: Excess Force, Angle of Application, or a below…
Last update: 11/08/2023, 15:21
RYOBI Angle Grinder disc has overtightened and jammed
An overtightened or jammed disc is usually caused by the disc not being installed correctly, causing it to overtighten. To fix this issue and prevent this from happening again, you’ll need to remove and refit the disc.
Last update: 29/08/2023, 13:25
Can’t remove cutting disc from Angle Grinder
Typically, a cutting disc can be hard to remove because the locking nut was overtightened when fitted to the grinder. A disc will tighten under loading, so excessive tightening will cause issues with removal, that may require a pin spanner or wrench…
Last update: 01/08/2023, 11:27
RYOBI Blower Vacuum won’t start
If your RYOBI battery powered Blower Vacuum won’t start, first check if the battery is low. Check the battery has at least 1 solid bar on it’s fuel gauge. If there is a flashing single bar, it's indicating the battery is fully discharged. Recharge…
Last update: 16/08/2023, 11:52
RYOBI Blower Vacuum can’t switch between modes
If your RYOBI Blower Vacuum can’t switch between modes, it may be because of a build-up of debris in the lever or deep inside the elbow.
Last update: 26/08/2022, 14:33
RYOBI 2400W Fixed Tube Blower low on power
If your RYOBI 2400W Fixed Tube Blower has low power, it may be because you’re using too many extension leads, or the lead is too long. It is recommended to use a heavy-duty extension lead no longer than 25m.
Last update: 29/08/2022, 10:14
What to do if your RYOBI 18V HP Garden Vacuum & Sweeper suddenly stops
If your RYOBI 18V HP Garden Vacuum and Sweeper suddenly stops, at the top of the handle there is a red LED - if this blinks, it means the locking pin hasn’t been fully tightened. If this happens, check that the pin is finger-tight until the LED goes…
Last update: 13/10/2022, 13:20