How to load nails into a RYOBI 18V 16ga Brad Nailer
Last update: 05/09/2024, 17:34
Applicable Models
R16GN18, R18NL16-0
Before you begin:
- Make sure that you have 16ga C Brad Nails as any other gauge will damage the Nailer.
- We recommend the PowerFit C Series Galvanised Brad Nails Project Pack - 4000 Pack
| Step | Action |
|---|---|
| 1. | Disconnect the battery from the Nailer before loading nails into the magazine. |
| 2. | Pull back the tension latch on the side of the magazine until it clicks and stays at the back or bottom of the magazine. |
| 3. | Load the nails into the rear of the magazine, past the tension latch, and as far towards the nose as possible. |
| 4. | Push the release button and the tension latch will spring and hold the loaded nails in place - not doing so will not hold the nails in the magazine. |
Additional Support
Image
MY RYOBI
Image
PRODUCT MANUALS
Image
WARRANTY
Image
WHERE TO BUY
Image
SAFETY NOTICES
Image
