How to assemble the track for a RYOBI 18V Track Saw

Last update: 06/10/2023, 12:55

Applicable Models

RPLS18X

 

Step Action
1 First you need the smaller of the supplied wrenches, located at the back of the saw. 
2 Use this to loosen the connector bars on the bottom side of one of your tracks, then slide them both out so they are sticking out about halfway off the track. 
3 Slide these ends into the corresponding slots on the other track. 
4 Then, rest a straight edge like a spirit level across the join to ensure the two sections are aligned straight across.
5 Fasten the connector bars down on both tracks to secure them in place. 
6 Slide the track clamp into either one of the two slots on the bottom of the track. This is used to fasten the track onto the material being cut. 

Additional Support