SEARCH results
20 Matching results
Bit slips out of RYOBI Drill Driver when driving screws
Bits can slip if the tips are very worn or are poor quality. Try inspecting the tip of the Bit to ensure it is not excessively worn. You should also make sure you're using the correct Bit for the fastener. Refer to the fastener packaging for correct…
Last update: 22/08/2022, 17:09
Can't tighten Drill Driver Bit in RYOBI Drill Driver chuck
The chuck securing screw has potentially loosened - tighten to avoid dropping Bits all the way into the bottom of the chuck. Depending on the type of chuck, make sure when tightening that the Bit is seated on the chuck jaws with equal seating /…
Last update: 03/02/2023, 16:01
Ryobi 36V Battery reads fully charged but won’t work in my tool
Firstly, put the battery in another tool to check that the fault lies with the battery and not the tool. Next, check that the terminals on your battery and tool are free from any debris or dirt. If you do find that your battery or tool needs to be…
Last update: 15/11/2022, 11:12
Why is my RYOBI 36V battery is flashing?
If all LEDs are flashing or if the first and last LED are flashing, this could indicate that the battery has overheated. Allow your battery to cool before attempting to charge or use it in a tool. (Cooling could take between 15-20 minutes, depending…
Last update: 15/11/2022, 11:23
RYOBI 36V Battery doesn’t last long enough
On warmer days, high ambient temperatures can increase the temperature of the battery. This will cause a reduction in runtime and performance. Allow your batteries to cool before you begin using them. Ensure that you are using the right size battery…
Last update: 15/11/2022, 11:40
How should I store my RYOBI 36V Battery?
Charge your battery to at least 50%. Store your battery in a cool, dry place no warmer than 38℃. Don’t leave it in direct sunlight or in a car during hot weather. When storing your battery, don’t leave it on the charger or in a tool as this may…
Last update: 15/11/2022, 12:04
Cannot tighten Drill Driver Bit in RYOBI Drill Driver chuck
Check that the chuck securing screw has potentially loosened – tighten clockwise with a matching bit (PH3 or Torx T30 usually) This occurs when Bits are dropped all the way into the bottom of the chuck.
Last update: 11/09/2024, 16:11
Additional Support
MY RYOBI
PRODUCT MANUALS
WARRANTY
WHERE TO BUY
SAFETY NOTICES
