5 Matching results
Bit slips out of RYOBI Drill Driver when driving screws
Bits can slip if the tips are very worn or are poor quality. Try inspecting the tip of the Bit to ensure it is not excessively worn. You should also make sure you're using the correct Bit for the fastener. Refer to the fastener packaging for correct…
Last update: 22/08/2022, 17:09
Can't tighten Drill Driver Bit in RYOBI Drill Driver chuck
The chuck securing screw has potentially loosened - tighten to avoid dropping Bits all the way into the bottom of the chuck. Depending on the type of chuck, make sure when tightening that the Bit is seated on the chuck jaws with equal seating /…
Last update: 03/02/2023, 16:01
How to avoid poor/no suction with a RYOBI Wet & Dry Vacuum
If your RYOBI Wet & Dry Vacuum has poor or no suction, it may be because the filter is dirty and needs to be cleaned. It could also be because the filter is too old to be cleaned, and needs to be replaced. We also recommend you check and empty the…
Last update: 03/02/2023, 11:44
How to swap out your RYOBI Wet & Dry Vacuum filter
To swap out the filter that's used for dry pickup for the one used for wet, simply take it off and grab the foam filter designed for wet pickup and slide it over. Make sure you place it on nice and firm so it protects all the insides. If you use the…
Last update: 19/09/2022, 16:43
How to clean your RYOBI Wet & Dry Vacuum & filter
We recommend straight after you use your machine for wet vacuuming, to clean it and have it setup ready for next time - particularly if the next time is to use the dry feature. The first step is to drain all the water out and then wipe and clean the…
Last update: 26/09/2022, 11:41