5 Matching results
RYOBI Angle Grinder disc has overtightened and jammed
An overtightened or jammed disc is usually caused by the disc not being installed correctly, causing it to overtighten. To fix this issue and prevent this from happening again, you’ll need to remove and refit the disc.
Last update: 29/08/2023, 13:25
Can’t remove cutting disc from Angle Grinder
Typically, a cutting disc can be hard to remove because the locking nut was overtightened when fitted to the grinder. A disc will tighten under loading, so excessive tightening will cause issues with removal, that may require a pin spanner or wrench…
Last update: 01/08/2023, 11:27
What to do if your RYOBI Lawn Mower isn't catching grass
Firstly, check for blockages. Blockages usually occur in the chute between the mower deck & catcher, which block airflow and prevent grass from being thrown to the back of the catcher. Mowing in wet or unruly conditions are often the cause of this…
Last update: 25/11/2022, 15:09
What to do if your RYOBI Petrol Lawn Mower is running roughly
Stale fuel can cause engines to run poorly, fuel starts to lose its volatility after 30 days. Dirty or old air filters/spark plugs should be replaced for optimal performance. Always try to use fresh fuel in your mower and replace the consumable…
Last update: 16/10/2023, 15:39
What to do if your RYOBI Petrol Lawn Mower runs for a minute then stops
Make sure that you have fresh fuel in the lawn mower (less than 30 days old). Ensure that your air filter is free from any dust and debris - check that the throttle lever is set in the running position.
Last update: 16/10/2023, 17:44