14 Matching results
Why does my RYOBI Angle Grinder keep cutting out?
Angle Grinders are commonly equipped with several user safety and tool protection systems, such as overload, over-temperature, and anti- kickback. Consider the following that could be causing the issue: Excess Force, Angle of Application, or a below…
Last update: 11/08/2023, 15:21
RYOBI Angle Grinder disc has overtightened and jammed
An overtightened or jammed disc is usually caused by the disc not being installed correctly, causing it to overtighten. To fix this issue and prevent this from happening again, you’ll need to remove and refit the disc.
Last update: 29/08/2023, 13:25
Can’t remove cutting disc from Angle Grinder
Typically, a cutting disc can be hard to remove because the locking nut was overtightened when fitted to the grinder. A disc will tighten under loading, so excessive tightening will cause issues with removal, that may require a pin spanner or wrench…
Last update: 01/08/2023, 11:27
Why are there grooves in the timber when using a RYOBI Thicknesser?
If you're getting grooves in the finish surface of the timber when using a RYOBI Thickness Planer (also known as a Thicknesser), it's most likely caused by damage to one or both cutters from a foreign object in the wood like a nail. The cutter/s…
Last update: 02/09/2022, 16:52
Why does my RYOBI Thicknesser stop during use?
If during use your RYOBI Thicknesser just stops, it’s probably because you’re attempting to remove too much material in a single pass, which can overload the motor. Simply hit the stop button, wind up the handle and then press the overload button to…
Last update: 02/09/2022, 16:55
Why are the feed rollers slipping in my RYOBI Thicknesser?
There are several possible causes for this resulting in the rollers requiring replacement from a service agent. It could be caused by general wear if the machine is older or the rollers are damaged from allowing them to do all the work without ample…
Last update: 02/09/2022, 16:57
What to do if your RYOBI Thicknesser blades wear unevenly
If your RYOBI Thickness Planer blades wear unevenly, this can occur from consistently feeding narrow width timbers in at the same position. When planing narrow width timber, try to mix up where you feed it into the machine as this process results in…
Last update: 02/09/2022, 16:58