How to use the mowers LED interface? Warning LED’s

HIGH LOAD/OVERLOAD
Mower is nearing its max current limit and is under heavy load. If this is continually triggered, then consider increasing the cutting height, use 2 batteries or check if the catcher is full. If you cut wet grass, try cutting it at a higher height and let the grass dry before lowering the height.

CATCH/MULCH
Mower cannot start because the mulch plug or catcher is not installed. Install correctly to allow the mower to start. Ensure the bar is sitting in the slot across the back of the mower.

BLADE CHECK
This is triggered as a reminder to check the blades condition. Remove batteries and closely inspect the blade for chips and dullness. If found, then replace with a new blade. The blade change U-Bolt is located underneath the front of the battery compartment.

*NOTE: When the blue ‘BLADE CHECK’ light illuminates, hold the battery button on the dashboard for 5 seconds to reset.